GPL BRASIL
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Conexão

Go down

Conexão Empty Conexão

Post by leomenegucci 28/11/2007, 11:45

Estas modificações podem ajudar a ter uma conexão melhor e mais estável durante o jogo. No meu caso ajudou muito.

Primeiro faça um beckup da seu arquivo core.ini.

Depois copie as linhas abaixo sobre a parte comunications

[ Communications ]
alternate_ip_addr_lookup = 1 ; 0 = No alternate lookup * 1 = Use alternate way
ip_addr_lookup_timeout = 5 ; Timeout to find own IP address. Default = 2 sec.
disable_network = 0 ; 0 = No * 1 = Yes
disable_modem = 1 ; 0 = Modem enabled * 1 = Modem disabled
disable_tcp_ip = 0 ; 0 = No * 1 = Yes
disable_ipx = 1 ; 0 = No * 1 = Yes
ignore_net_read_errors = 1 ; 0 = No 1 = Yes *
ignore_net_send_errors = 1 ; 0 = No 1 = Yes *
log_server_comm_errors = 0 ; 0 = No * 1 = Yes
log_server_connect_status = 0 ; 0 = No * 1 = Yes
net_server_port = 32766 ; Default = 32766. Range is 21 long.
clock_adj_delay = 4 ; Only used when synch_method = 0 (see [ Tasks ])
show_meters = 0 ; 0 = Off * 1 = On Alt-m to toggle
bcast_listserv =
bcast_port = 6970 ; Status broadcast port number. Default = 6970.
bcast_send_freq = 30 ; Default = 4. For VROC, don't go lower than 30.
bcast_augment_status = 0 ; 0 = No * 1 = Yes (prepend status with ip address)
bcast_send_disable = 0 ; 0 = No * 1 = Yes (disable server local broadcasts)
bcast_ping_port = 6971 ; Port number for ping by VROC & GSB. Default = 6971.
bcast_ping_disable = 0 ; 0 = No * 1 = Yes (disable server response to pings)
bcast_listserv_req = ? ; Client race list request string. Start with '?'.
bcast_listserv_req_freq = 10.0 ; Refresh rate in seconds. Default = 10 secs.
bcast_recv_disable = 0 ; 0 = No * 1 = Yes (disable)
net_mdm_client_send_every = 3
net_mdm_client_send_size = 384
net_mdm_server_send_every = 3
net_mdm_server_send_size = 384
net_lan_client_send_every = 3
net_lan_client_send_size = 384
net_lan_server_send_every = 3
net_lan_server_send_size = 384
net_use_mdm_bandwidth_for_tcp_ip = 0


Intale o bwpach e o gpldicofix.

Instuções e arquivos podem ser baixados neste link http://forums.speedgeezers.net/index.php?showtopic=24959 que está em inglês.
leomenegucci
leomenegucci
Piloto de GP2
Piloto de GP2


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum